Diagnostic procedure (page 4 of 5)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 4 of 5
Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.
| Are all above items normal? | No | Replace the fuel injector. | |
| 9 | Is the air cleaner element free of clogging? | Yes | Go to the next step. |
| No | Replace the air cleaner element. | ||
| 10 | Perform the spark test. (See SPARK TEST .) Is strong blue spark visible at each cylinder? | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. | ||
| 11 | Install the fuel pressure gauge between the fuel filter and fuel distributor. Short check connector terminal F/P to body GND using a jumper wiring. Turn the ignition switch to the ON position (Engine off). Is the fuel line pressure correct with ignition switch at ON? (See FUEL LINE PRESSURE INSPECTION [LF] .) | Yes | Go to the next step. |
| No | Zero or low: Inspect the fuel pump relay and fuel pump circuit. Inspect the fuel line for clogging. If there is no malfunction, replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION | ||
| [LF] .) High: Replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION | |||
| [LF] .) | |||
| 12 | Inspect the following PIDs: • ECT • O2S11 (When engine can be started.) • O2S12 (When engine can be started.) • MAF (See PCM INSPECTION [LF] .) Are PIDs normal? | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. |
13
Perform the purge
Yes
Go to the next step.
control inspection. (When engine can be
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.