Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 3
blower fan to any speed.
Does the A/C compressor engage?
following and repair or replace if necessary:
If all items are normal, go to the next step.
• Refrigerant charging amount
• Open circuit in wiring harness between A/C relay and PCM terminal 11
• Seized A/C magnetic clutch
• A/C magnetic clutch malfunction
4Connect the M-MDS or equivalent to DLC-2.
Access AC_REQ PID.
Start the engine and idle it.
Turn the A/C switch and fan switch on.
Does AC_REQ PID read on?
YesGo to the next step.
NoInspect the following:
• Refrigerant pressure switch operation
• The A/C switch is stuck open.
• Open or short circuit between refrigerant pressure switch and PCM terminal 1AU
• Open circuit of blower motor fan switch and resistor (if blower motor does not operate)
• The evaporator temperature sensor and A/C amplifier

5

Inspect cooling fan control

Yes

Go to the next step.

system operation.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.