Diagnostic procedure (page 3 of 3)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 3 of 3
| (See COOLING FAN CONTROL SYSTEM INSPECTION .) Does the cooling fan control system function properly? | No | Repair or replace the malfunctioning part. | |
| 6 | Is the drive belt normal? | Yes | Go to the next step. |
| No | Replace the drive belt. | ||
| 7 | Is there leakage around the heater unit in passenger compartment? | Yes | Inspect and service heater for leakage. |
| No | Go to the next step. | ||
| 8 | Is there leakage at the coolant hoses and/or radiator? | Yes | Replace the malfunctioning part. |
| No | Go to the next step. | ||
| 9 | Cool down the engine. Remove thermostat and inspect operation. (See THERMOSTAT REMOVAL/INSTALLATION | Yes | The engine coolant temperature and thermostat are normal, inspect engine block for leakage or blockage. |
| [LF] .) (See THERMOSTAT INSPECTION [LF] .) Is thermostat normal? | No | Access ECT PID. Inspect for both ECT PID and temperature gauge readings. If temperature gauge on instrument cluster indicates normal range but ECT PID is not same as temperature gauge reading, inspect ECT sensor. If temperature gauge on instrument cluster indicates overheating but ECT PID is normal, inspect temperature gauge and heat gauge unit. |
10
- Verify test results.
- If normal, return to diagnostic index to service any additional symptoms.
(See ENGINE SYMPTOM TROUBLESHOOTING [LF] .)
- If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
- If vehicle is repaired, troubleshooting completed.
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.