Diagnostic procedure (page 5 of 5)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 5 of 5
Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.
| system.Is cruise control system normal? | |||
| 14 | Inspect the front HO2S. (See FRONT HEATED OXYGEN SENSOR (HO2S) INSPECTION [LF] .) Is the front HO2S normal? | Yes | Go to the next step. |
| No | Replace the front HO2S. (See FRONT HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION | ||
| [LF] .) | |||
| 15 | Inspect the evaporative purge hose between the fuel tank and the purge valve. Does fuel flow into evaporative purge hose? | Yes | Inspect the check valve (two- way). (See FUEL TANK INSPECTION [LF] .) |
| No | Go to the next step. | ||
| 16 | Disconnect the vacuum hose between the purge solenoid valve and the intake manifold from the purge solenoid valve side. Plug opening end of vacuum hose. Drive the vehicle. Does the engine condition improve? | Yes | Go to the next step. Inspect if the purge solenoid valve is stuck open mechanically. Inspect the evaporative emission control system. |
| No | Go to the next step. | ||
| 17 | Visually inspect the CMP sensor and projections of camshaft pulley. Are CMP sensor and projections of camshaft pulley normal? | Yes | Go to the next step. |
| No | Replace the malfunctioning part. | ||
| 18 | Inspect the EGR system. (See EGR CONTROL SYSTEM INSPECTION .) Is the EGR system normal? | Yes | Go to the next step. |
| No | Replace the malfunctioning part. |
19
Is the engine
Yes
Inspect the following:
compression correct?
- Valve timing
- Internal transaxle part (AT)
- Clutch (MT)
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.