Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Fuel tank side (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Emission System
Engine performanceFuel tank side · page 2 of 3
  1. Perform the following SST (Evaporative Emission System Tester 134-01049) self-test:

NOTE: If the tester does not work correctly during self-test, refer to the tester operators manual for more detailed procedures.

  1. Verify the gas cylinder valve is closed and the control valve located on the tester is in the TEST position. All tester display should be off at this time.
  2. Connect the long hose (part of SST ) to the tester.
  3. Connect the manifold assembly (part of SST ) to the long hose as shown in Fig. 4.
ENGINE PERFORMANCE – Emission System – figure
Fig. 4: Connecting Manifold Assembly To Long Hose
Courtesy of MAZDA MOTORS CORP.
  1. Open the gas cylinder valve and verify the gas cylinder regulator left gauge reads 10 to 12 psi (preset at factory).
    • If not, refer to the tester operators manual to contact tester manufacturer.
  2. Press the ON/OFF switch to turn on the SST and make sure the left display reads 0.0 .
  3. Turn the control valve on the tester to the FILL position.
  4. Verify the left display reading is within 13.9 to 14.0 in of water .
    • If not, adjust the pressure using the regulator knob located on the right side of the tester.
  5. Turn the control valve to TEST position and press the START switch.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.