Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 4 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 4 of 5

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

correct with ignition switch to ON position? (See FUEL LINE
PRESSURE
INSPECTION [LF] .)
Replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION [LF] .)
11Inspect variable intake air control operation. (See VARIABLE
INTAKE AIR
CONTROL
OPERATION
INSPECTION .)
Does VIS function properly?
YesGo to the next step.
NoRepair or replace the malfunctioning part.
12NOTE:
• The following test is for engine stalling with the A/C on concern. If other symptoms exist, go to the next step.
Connect pressure gauge to the A/C low and high side pressure lines.Turn the A/C on and measure low side and high side pressures.Are pressures within specifications? (See REFRIGERANT
PRESSURE
CHECK .)
YesGo to the next step.
NoIf A/C is always on, go to symptom troubleshooting
"No.24 A/C is always on or A/C compressor runs continuously". (See NO.24 A/C IS ALWAYS
ON OR A/C COMPRESSOR
RUNS CONTINUOUSLY [LF] .)
For other symptoms, inspect the following:
• Refrigerant charging amount
• Condenser fan operation
13Inspect for A/C cut-off operation. (See A/C Cut-off
Control System
Inspection .)
Does the A/C cut-off function properly?
YesGo to the next step.
NoInspect A/C cut-off system components.

14

Disconnect the vacuum

Yes

Inspect if purge solenoid valve

hose between the purge

is stuck open mechanically.

solenoid valve and the

Inspect the evaporative emission

intake manifold from

control system.

purge solenoid valve

(See PURGE CONTROL

side.

SYSTEM INSPECTION .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.