Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 2
Are all items normal?• Collapsed or restricted intake-air system
• Restricted fuel return line
NoService if necessary.
Repeat Step 4.
5Connect the M-MDS or equivalent to the
DLC-2.
Turn the ignition switch to the ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?
YesDTC is displayed:
Go to the appropriate DTC inspection. (See DTC TABLE [LF] .)
NoNo DTC is displayed:
Go to the next step.
6Install the fuel pressure gauge between the fuel pipe and the fuel distributor.
Start the engine and idle it.
Measure fuel line pressure during idle.
Is fuel line pressure correct during idle? (See FUEL LINE
PRESSURE
INSPECTION [LF] .)
YesGo to the next step.
NoLow:
• Inspect the fuel line for clogging.
• If there is no malfunction, replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION [LF] .)
High:
• Replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION [LF] .)
7Perform the spark test. (See SPARK TEST .)
Is strong blue spark visible at each cylinder?
YesInspect the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION [LF] .)
NoRepair or replace the malfunctioning part according to spark test result.

8

  • Verify test results.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.