Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 2
Are there any DTCs displayed?NoNo DTC is displayed:
Go to the next step.
5Perform the electronic throttle control system operation inspection. (See ELECTRONIC
THROTTLE
CONTROL SYSTEM
INSPECTION .)
Does the electronic throttle control system function properly?
YesGo to the next step.
NoRepair or replace the malfunctioning part according to electronic throttle control system operation inspection results.
6Disconnect the vacuum hose between the purge solenoid valve and the intake manifold from purge solenoid valve side.
Plug opening end of vacuum hose.
Drive the vehicle.
Does the engine condition improve?
YesInspect the evaporative emission control system.
NoGo to the next step.
7Connect the M-MDS or equivalent to the DLC-2.
Access APP1, APP2, TP, MAF and VSS PIDs.
Monitor each PID while driving vehicle. (See PCM
INSPECTION [LF] .)
Are PIDs normal?
YesGo to the next step.
NoAPP1, APP2 PIDs:
Inspect the accelerator pedal position sensor.
TP PID: Inspect TP sensor.
MAF PID: Inspect MAF sensor.
VSS PID: Inspect VSS.
YesGo to the next step.
8
Access and monitor

BOO, CPP (MT),

No

If the BOO PID is not

CPP/PNP (MT), and TR

normal:

(AT) PIDs. Are PIDs values normal?

  • Inspect brake

(See PCM

switch, and related

INSPECTION [LF] .)

wiring harness for vibration or intermittent open/short circuit.

If the CPP PID is not normal:

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.