Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 3 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 3 of 3
NoGo to the next step.
9Install the fuel pressure gauge between the fuel pipe and fuel distributor.
Short check connector terminal F/P to body
GND using a jumper wiring.
Turn the ignition switch to the ON position.
Is fuel line pressure correct with ignition switch ON? (See FUEL LINE
PRESSURE
INSPECTION [LF] .)
YesGo to the next step.
NoZero or low:
Inspect the fuel pump relay and the fuel pump circuit. Inspect the fuel line for clogging.
If there is no malfunction, replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION
[LF] .)
High:
Replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION
[LF] .)
10Is the fuel line pressure held after ignition switch is turned off? (See FUEL LINE
PRESSURE
INSPECTION [LF] .)
YesGo to the next step.
NoInspect the fuel injector. (See FUEL INJECTOR
INSPECTION [LF] .)
If the fuel injector is normal, replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION
[LF] .)
11Disconnect a vacuum hose from purge solenoid valve and plug opening end of vacuum hose.
Start engine.
Is starting condition improved?
YesInspect if the purge solenoid valve is stuck open.
NoGo to the next step.
12Inspect the MAF sensor for following:
• Contamination
• MAF sensor terminal B voltage (GND circuit)
Is there any contamination?
YesRepair or replace the malfunctioning part.
NoGo to the next step.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.