Diagnostic procedure (page 2 of 2)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 2
| 4 | Perform the spark test. (See SPARK TEST .) Is strong blue spark visible at each cylinder? | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part according to spark test result. | ||
| 5 | Install the fuel pressure gauge between the fuel pipe and the fuel distributor. Start the engine and idle it. Measure fuel line pressure during idle. Is fuel line pressure correct during idle? (See FUEL LINE PRESSURE INSPECTION [LF] .) | Yes | Go to the next step. |
| No | Low: Inspect the fuel pump relay and fuel pump circuit. Inspect the fuel line for clogging. If there is no malfunction, replace the fuel pump unit (See FUEL PUMP UNIT REMOVAL/INSTALLATION | ||
| [LF] .) High: Replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION | |||
| [LF] .) | |||
| 6 | Inspect for variable valve timing control system operation. (See VARIABLE VALVE TIMING CONTROL SYSTEM OPERATION INSPECTION .) Does the variable valve timing control system function properly? | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. | ||
| 7 | Inspect for the variable intake air control operation. (See VARIABLE INTAKE AIR CONTROL OPERATION INSPECTION .) Does variable intake air control function properly? | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. | ||
| 8 | Remove and shake the PCV valve. Does the PCV valve rattle? | Yes | Go to the next step. |
| No | Replace the PCV valve. |
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.