Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Specification

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Intake Air System › Specification
Engine performanceSpecification
  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Disconnect the throttle body connector.
  4. Measure the resistance between throttle actuator terminals A and B.
    • If not as specified, replace the throttle body. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
    • If as specified, carry out the Circuit Open/Short Inspection .

Specification

AMBIENT TEMPERATURE SPECIFICATION

Ambient temperature (°C {°F})

Resistance (ohm)

Approx. 20 {68}

0.3-100

ENGINE PERFORMANCE – Intake Air System – figure
Fig. 14: Identifying Throttle Actuator Connector Terminals
Courtesy of MAZDA MOTORS CORP.

CIRCUIT OPEN/SHORT INSPECTION

  1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF] .)
  2. Inspect the following wiring harnesses for open or short (continuity check).

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.