Steering
- Make
- MG
- Model
- MGF Factory Workshop Manual
- Year
- 1995–2000
- Section
- General data › Steering
InformationSteering
STEERING
NOTE: The following steering geometry settings are given in degrees and minutes, decimal parts of a degree and millimetres. Steering and suspension geometry settings are for a vehicle at unladen weight.
| Front wheel alignment - toe out - per side | 0° 10’ ± 6’ |
| Front wheel camber - negative | 0° 30’ ± 0° |
| Front wheel caster - positive | 4° 50’ ± 1° |
| King pin inclination | 11° 40’ |
Overall steering ratio
| Manual steering | 20.8 : 1 |
| Power steering | 19.1 : 1 |
Rear suspension geometry
| Rear wheel alignment - toe-in - per side | 0° 10’ to ± 0 |
| Rear wheel camber - negative | 1° 0’ ± 0° 30’ |
0.21° ± 0.1° 1.105 mm ± 0.651 mm 30’ 0.50° ± 0.50° 3.315 mm ± 0.315 mm 4.83° ± 1.0° 29.98 mm ± 6.71 11.71° 78.71 mm
° 7’ 0.21° ± 0.12° 1.105 mm ± 0.76 mm 1.0° ± 0.50° 6.71 mm ± 0.315 mm
SUSPENSION
Front
| Type | Double wishbone with Hydragas springs, separate dampers and anti roll bar. |
Rear
| Type | Double wishbone with forward fitting tie bar. Hydragas springs, separate dampers and anti roll bar. |
Trim height
Height to wheel arch from hub centre at unladen weight:
| Front height | 368 ± 10 mm |
| Rear height | 363 ± 10 mm |
Parts & tools for this job For 1995 MG MGF
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: MG power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.