Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual25 · BF body
25 · Body & interior

INTERIOR AND EXTERIOR - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › INTERIOR AND EXTERIOR - Nissan 180SX S13 Workshop Manual
BF bodyINTERIOR AND EXTERIOR - Nissan 180SX S13 Workshop Manual

INTERIOR AND EXTERIOR

INTERIOR AND EXTERIOR

Exterior (Cont'd)

@ Windshield upper and side molding

@, @® Cowl top grille and hood rear sealing rubber

Method 1

Cut off top portion of molding and clean glass and panel surfaces. Cowl top grille

Brrr

Hood rear sealing rubber

Apply sealant to top portion of molding.

SBF211E Cut off lower portion of new molding.

(©) Hood front sealing rubber

Finish well to give it a {Hees front sealing rubber good appearance. Method 2

Sealing rubber bracket

1. Cut off sealant at glass end.

2. Clean the side on which panel was mounted.

3. Set molding

fastener and apply

sealant &

primer to body panel, and apply primer to

molding. Kg

Apply primer, Fastener Glass

Double-faced adhesive tape Dam rubber Apply sealant. SBF212E Apply primer.

© Center pillar finisher

4. Install molding by aligning the molding mark

located on center with vehicle center.

Be sure to install tightly so that there is no gap

Sealing washer

around the corner.

SBF513B

Pe.me

@ Windshield lower molding

é

It is mounted with screws.

Grommet

Sealing washer NgN Grommet SBF213E

BF-22

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.