INTERIOR AND EXTERIOR - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › INTERIOR AND EXTERIOR - Nissan 180SX S13 Workshop Manual
INTERIOR AND EXTERIOR
INTERIOR AND EXTERIOR
Exterior (Cont'd)
@) Door weatherstrip
@® Back door window lower molding
- Apply butyl! sealant where necessary Malding -- Molding fastener while installing the weatherstrip. (Set it when windshield glass [om] is installed.) Molding clip (9 places) Body panel
ay
Double-faced adhesive tape {When in- UW TM
stalling fas-
tener, heat body panel and fastener to approx. 30 t0 40°C .| SBF216E (86 to S6F401B8 104° F)].
(® Rear sight shield
Back door weatherstrip
White Vehicle enicie center cente Sealing washer BI
marking ae
Back window weatherstrip B Butyl seal Buy! \|ff »& Luggage side_/ seal upper garnish ‘ Body panel
a Z. ‘Back window
“upper garnish Body panel SBF217E SBF4240
() Back door window upper and side molding
Bonded on back door glass side.
@ @ Sun roof weatherstrip & lid weatherstrip
@ Rear panel finisher
33 mm (1.30 in) Apply primer before bonding, Sealing rubber
Sun roof lid Sun roof lid protector weatherstrip a
Sealant “
portion Roof panel Sun roof weatherstrip SBF544D SBF218E
BF-24
Parts & tools for this job For Nissan 180SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.