Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual25 · BF body
25 · Body & interior

WINDSHIELD AND WINDOWS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › WINDSHIELD AND WINDOWS - Nissan 180SX S13 Workshop Manual
BF bodyWINDSHIELD AND WINDOWS - Nissan 180SX S13 Workshop Manual

WINDSHIELD AND WINDOWS

WINDSHIELD AND WINDOWS

4

Windshield REMOVAL INSTALLATION

After removing moldings,

@ Use genuine Nissan Sealant kit or equivalent. Follow instructions furnished with

remove glass. it. - @ After installation, the vehicle should remain Stationary for about 24 hours.

Cutting sealant

© Do not use sealant which is more than 12 months past its production date.

\ @ Do not leave cartridge unattended with its Cap open. =

® Keep primers and sealant in a cool, dry place. Nissan recommends that they are

Glass stored in a refrigerator, ® Be sure to install moldings. Clean bonding surface thoroughly.

WARNING: Keep heat or open flames away as Glass side

primers are flammable.

SB8FO34B Body side

CAUTION: Be careful not to scratch glass when removing,

mnt SBF413B8 ] ] Body side Glass side

tnstali spacers to panel with Install dam rubber & spacers with double-faced adhesive tape. double-faced tape. Vehicle Spacer center —— (0.98) | ‘al

Seen IK Tt00

2228) 25 (0.98 '

Unit: mm (in)

bber

joint portion

500 | Vehici ter . . Approximately adhesive (19.09) anicie cen a t Spacer mounting 2mm (0.31 in) tape : po SBFISGE

(Spacer should be installed

at slit portion of dam rubber.) SBF1I98E ¥ a Install molding fastener. Apply primer A, When installing it, heat body panel and Dam fastener to approx. 30 to 40°C (86 to Glass 104"F) °F),

Upper & side molding

, fastener f Fastener

Double-faced i adhesive tape Lower side Glass of glass

| SBFIS7E

, SBF719C

CAUTION: Altow primers to dry for 10 to 15 minutes before proceeding to the next step.

BF-28

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.