Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual07 · EF&EC - Fuel & Emission Control
07 · Engine

DIAGNOSTIC PROCEDURE - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › DIAGNOSTIC PROCEDURE - Nissan 200SX S12 Workshop Manual
EF&EC - Fuel & Emission ControlDIAGNOSTIC PROCEDURE - Nissan 200SX S12 Workshop Manual

DIAGNOSTIC PROCEDURE

DIAGNOSTIC PROCEDURE

Driveability (Cont'd)

5. Clean injectors or adjust to specifications. CA20E engine Check injectors or try replacement injectors. 6, Perform electronic control system inspection, Check the following using circuit tester, © Injector circuits © Air regulator circuit ¢ Exhaust gas sensor hester circuit Follow the procedure in ELECTRONIC CON- TROL SYSTEM INSPECTION (Pages EF & EC-49- 76). 7, Check idle mixture ratio. 1) Warm up engine to operating temperature. ‘This side or opponite ude 2) Verify that the diagnosis made selector is secszsa! turned “OFF" (CA2GE) or fully counterclock- wise (CA1BET). 3) Verify that engine is still at operating tempera- CAIBET ongine ture 4) Race engine two or three times under no-load, then run engine at idle speed. 5) Look at inspection lamps (red and green).

8. Check mixture ratio at middle engine speed, 1) Verify that inspection lamps on control unk blink simultaneously at idle. 2) Race engine two or three times under no-|or When both inspection lamps blink, it indicates that then run engine at idle speed. the idle mixture ratio is correct, 3) Gradually increase engine speed and check foi 7) If N.G,, adjust idle mixture ratio by turning operating {blinking} of the inspection lamps variable resistor (CA1BET) or air by-pass screw different engine rpms {up to approximately (CA20E) on air flow meter so that irispection 2,000 rpm}. lamps blink simultaneously, * If both inspection lamps continue to blink Refer to CAUTION (f.) on page EF & EC-35, during idle to 2,000 rpm range, it indicates thet the idle mixture ratio is correct. 4} IfN.G., replace air flow meter and adjust idk mixture ratio as per step 7.

9. Perform driveability test. Re-evaluate vehicle performance.

EF & EC-38

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.