DIAGNOSTIC PROCEDURE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › DIAGNOSTIC PROCEDURE - Nissan 200SX S12 Workshop Manual
DIAGNOSTIC PROCEDURE
DIAGNOSTIC PROCEDURE
Engine Startability
START
7 Check starting system and Battery NG. Roauee Repair or replace components as necessary. OK. * NG.
2. Check fuel level. [AS at supply foal. OK. le i le
x. NG. [+] Repair or replace components as necessary,
3. Check Ignition system. oxy 1 NG. 4, Partorm E.F.IVE.C.C.S. self-diagnosis, Repair or replace components as necessary. [——+|_ ox]
Perform electronic control system inspection || Repair or replace componen ‘and check E.G.A. valve operation.
0. *| 1 6, Inepect engine and E.F.I,/E.C.C.S. for air Locate and repair.
Perform electronic control system inspection{
1, Check starting system and battery charging |.
and check E.G.R. valve operation.
: aystem. 1) Check starter operation. Check the following using circuit tester, i 2) Check battery voltage.
Air regulstor circuit
| Repair or replace as necessary.
Follow the procedure in ELECTRONIC CON
2. Check fuel level. If fuel level is low or empty, add fuel. TROL SYSTEM INSPECTION (Pages EF & { £C-49 - 76).
3. Check ignition system, Inspect engine and E.F./E.C.C.S. for air ls} 1} Check ignition wiring. 2}. Check distributor rotor head. Refer to DRIVEABILITY. 3) Check spark plug. 4, Perform E.F.I/E.C.CS. self-diagnosis. Fallow the procedure in £.F.i./E.C.C.S, SELF-DIAG- NOSIS {Pages EF & EC-41 - 48).
EF & EC-40
Parts & tools for this job For Nissan 200SX
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.