I

I

- Using the thrust plate (15) ref. (-)0.316N
and 2 levers remove the right hand drive shaft.

II

- Remove :
- the protector (16),
- the starter motor (17).

III

- Fit the engine retaining tool (ref. (-)0.316P),
- the longest hook (18) to the front cross member,
- the short hook (19), together with the sling in the hole in the rear cross member.
- Select the best positioned hole in the front hook to which to secure the sling.

IV

- Remove the dipstick (20).
- Disconnect the speedometer drive cable (21).
- Place a hydraulic stand under the gearbox.
- Apply light pressure to it and remove the last bolt from the left hand mounting.

V

- Lower the gearbox so that the weight of the engine is resting on the sling.
- Remove :
- the TDC sensor (22).

VI

- the left hand mounting (23),
- the lower bolts (24) that secure the gearbox to the engine.