Cayenne S (9PA) V8-4.5L (2003)
Note!
^
The left-hand clamping washer of joint boot must be clamped in such a way that the clamping washer lug forms one line with the steering
pinion!
^
The left-hand clamping washer of joint boot must be clamped in such a way that the clamping washer lug faces the direction of the journey
horizontally with front axle carrier (suspension subframe)!
^
Failure to do this can result in narrow passages on the left-hand side in the vicinity of the feed and return lines and on the right-hand side in the
vicinity of the heat insulation plate!
^
Fit joint boot (not in twisted condition) and secure with -new clamping washers- (Use pliers for clamping washers 74).
^
Check that joint boot is not worn (cracks, slots) and that sealing surfaces are clean.
^
When fitting the ball joints, ensure that the bevel pinions are clean! Remove dirt or grease on bevel pinions, e.g. with a lint-free cloth. Do not
use cleaning agent/solvent.
^
Observe airbag safety instructions
^
Fit driver airbag unit
^
Observe notes on steering-gear centre position in the section describing front track adjustment
^
Steering-angle sensor calibrations