Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K806 Engine - K1607 Engine - K16 with VVC08 Engine - L Series09 Emission control10 Engine management system - MEMS11 Engine management system - EDC12 Fuel delivery system13 Cooling system - K Series14 Cooling system - L Series15 Manifold & exhaust systems16 Clutch17 Manual gearbox - R6518 Manual gearbox - PG119 Automatic gearbox - CVT20 Automatic gearbox21 Drive shafts22 Steering23 Front suspension24 Rear suspension25 Brakes26 Restraint systems27 Body28 Heating & ventilation29 Air conditioning30 Wipers & washers31 Electrical32 Instruments
Rover 200 Workshop Manual (1995-1999)25 · Brakes
25 · Brakes

Brake light switch (Brakes)

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Adjustments › Brake light switch
BrakesBrake light switch · page 1 of 2
Diagram
  1. Tighten equaliser adjusting nut until rear wheels drag slightly when turned.
  2. Release handbrake lever and check that rear wheels do not drag when turned. readjust if necessary.
  3. Apply handbrake one notch at a time and count the number of notches until both rear wheels lock. Readjust if necessary.
  4. Release handbrake lever.
  5. Fit ash tray to rear console.
  6. Remove stand(s) and lower vehicle.

BRAKE LIGHT SWITCH

Service repair no - 70.35.41

Adjust

Brake light switch – Service repair no - 70.35.41
  1. Release 3 turnbuckles securing fuse box cover to lower fascia.
  2. Remove fuse box cover.
Brake light switch – Remove fuse box cover.
  1. Release 2 turnbuckles securing closing panel to underside of fascia.
  2. Remove closing panel.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.