Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K806 Engine - K1607 Engine - K16 with VVC08 Engine - L Series09 Emission control10 Engine management system - MEMS11 Engine management system - EDC12 Fuel delivery system13 Cooling system - K Series14 Cooling system - L Series15 Manifold & exhaust systems16 Clutch17 Manual gearbox - R6518 Manual gearbox - PG119 Automatic gearbox - CVT20 Automatic gearbox21 Drive shafts22 Steering23 Front suspension24 Rear suspension25 Brakes26 Restraint systems27 Body28 Heating & ventilation29 Air conditioning30 Wipers & washers31 Electrical32 Instruments
Rover 200 Workshop Manual (1995-1999)03 · Information
03 · General

Engine - ’l’ series

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
General data › Engine - ’l’ series
InformationEngine - ’l’ series

ENGINE - ’L’ SERIES

Type8 valve SOHC
Cylinder arrangement4 in line - transverse
Bore84 mm
Stroke89 mm3
Capacity1994 cm
Firing order1 - 3 - 4 - 2
RotationClockwise, viewed from the front of the engine
Cylinder head warp - maximum0.10 mm

Lubrication

System TypeWet sump, crankshaft driven eccentric rotor pump
Pressure at idle0.7 bar
Relief valve opening pressure4.5 bar
Pressure at 3000 rev/min hot3.8 bar
Oil pressure warning light switch opens0.4 to 0.7 bar
Oil filterFull flow with disposable canister

FUEL SYSTEM - ’K’ SERIES

Electronic fuel injection dataSee Engine tuning data.

Fuel Pump

TypeElectric immersible
Pump maximum pressure at 13.5V4.1 bar
Regulated injection pressure range3.0 ± 0.2 bar

FUEL SYSTEM - ’L’ SERIES

Fuel filterBosch 0450 906172
Fuel injection pumpBosch rotary
  MechanicalVP21
  ElectronicVP37
Fuel injectorsBosch two spring, needle lift sensing on number one injector

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.