Workshop Manuals Factory service & repair Rover
01 Introduction02 Fuse details03 Earth points and header joints04 Description and operation05 Connectors
Rover 400 Electrical Library (1998 model year on)04 · Description and operation
04 · General

Handset Battery Replacement

Make
Rover
Model
400 Electrical Library
Year
1998 model year on
Section
Anti-theft and engine immobilisation › Handset Battery Replacement
Description and operationHandset Battery Replacement

Handset Battery Replacement

Dependant on usage, the CR2032 type battery in the handset should last for three years. When the battery is near the end of its life, unlocking the doors will result in a rapid flashing of the anti-theft LED. A reduction in operating range may also be noticed.

To change the battery, carefully prise open the handset casing at the key ring end, taking care not to damage the seal. Slide the battery out, without bending the clip or touching any of the contact surfaces. Press and hold each handset button for five seconds, to allow residual power to discharge.

Without touching the contact surfaces, carefully slide a new battery into the clip, ensuring that the side marked ’+’ faces the clip. Snap together the two halves of the handset case.

Ensure the vehicle is unlocked using the key. Operate the RH button at least four times, until the vehicle is locked. The vehicle can then be unlocked with the handset and will operate normally.

Parts & tools for this job For 1998 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.