Information (page 3 of 4)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Information
SuspensionInformation · page 3 of 4
| A | Self – locking nut | I | Spindle nut |
| B | Flange nut | J | Castle nut |
| C | Castle nut | K | Caliper bracket mounting bolt |
| D | 6 mm bolt | L | Self – locking nut |
| E | Damper pinch bolt (self – locking bolt) | M | Self – locking bolt |
| F | Damper fork nut (self – locking nut) | N | Self – locking nut |
| G | Self – locking bolt | O | Self – locking bolt |
| H | Castle nut | P | Self – locking nut |
CAUTION: Fit new self – locking nuts after removal.
- The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushing are tightened.
- Torque the castle nut to the lower torque specification, then tighten sufficiently to permit alignment with the next available pin hole. Do not align the nut by loosening.
- Wipe off the grease before tightening the nut at the ball joint.
Parts & tools for this job For Rover 600
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Rover 600 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.