Workshop Manuals Factory service & repair Rover
Rover 200/400 Coupé, Cabriolet & Tourer Workshop Manual17 · Automatic gearbox
17 · Transmission

Refit (page 2 of 2)

Make
Rover
Model
Coupé, Cabriolet & Tourer 200/400 Coupé, Cabriolet & Tourer Workshop Manual
Section
Repairs
Automatic gearboxRefit · page 2 of 2
  1. Fit distributor, see ENGINE MANAGEMENT SYSTEM – PGM-FI – Repairs.
  2. Connect oil cooler hoses, tighten clips.
  3. Connect throttle control cable at lever, lightly tighten locknut.
  4. Connect lock-up solenoid valve harness at multi-connector.
  5. Connect speedometer cable to gearbox, rotate gaiter 90° to engage clip.
  6. Connect earth lead to gearbox; tighten bolt to 35 Nm.
  7. Fit starter motor, see ELECTRICAL – Repairs.
  8. Fit battery tray, tighten bolts to 9 Nm.
  9. ABS6: Align pump feed hose and throttle cable bracket to battery tray, fit bolts and tighten to 9 Nm.
  10. Connect trunking to throttle housing and breather pipe, tighten clip.
  11. Connect trunking to air cleaner.
  12. Connect vacuum pipes to air cleaner.
  13. Fit air duct, tighten bolts to 25 Nm.
  14. Locate expansion tank hose in clips.
  15. Fit side branch to air duct and engage clip.
  16. Fill gearbox with correct quantity and grade of fluid see INFORMATION – CAPACITIES, FLUIDS AND LUBRICANTS.
  17. Fit battery into tray, fit clamp and tighten bolt. Connect both battery leads.
  18. Fit underbelly panel, see BODY – Repairs.
  19. Remove stand(s) and lower vehicle.
  20. Check engine timing, see MAINTENANCE.
  21. Check/adjust throttle control cable, see Adjustments.

Parts & tools for this job For Rover Coupé, Cabriolet & Tourer

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.