Engine management system - PGM-Fi: Description and operation (page 2 of 3)
- Make
- Rover
- Model
- Coupé, Cabriolet & Tourer 200/400 Coupé, Cabriolet & Tourer Workshop Manual
- Section
- Description and operation
Engine management system - PGM-FiDescription and operation · page 2 of 3
- Electronic control unit (E.C.U.)
- Atmospheric pressure (PA) sensor
- Idle mixture (IMA) sensor
- Fuel relay
- Inertia switch
- Neutral switch (park) – Automatic
- Fuel pump
- Air conditioner switch
- Vehicle speed sensor
- Throttle angle sensor
- Electronic air control valve (EACV)
- Fast idle control solenoid valve
- Intake air temperature (TA) sensor
- Ignition timing inspection connector
- Alternator
- Injectors resistor pack
- No.4 Injector
- No.3 Injector
- No.2 Injector
- No.1 Injector
- Resonator control solenoid
- Compressor clutch relay – if fitted
- Purge control valve – catalyst equipped engine
- Manifold absolute pressure (M.A.P.) sensor
- Oxygen sensor – catalyst equipped engine
- Lock – up control solenoid – if fitted
- Engine coolant temperature (TW) sensor
- Distributor
- Distributor cap
- Rotor arm
- Igniter unit
- Ignition coil
- Crank sensor
- T.D.C. sensor
- Cylinder sensor
Parts & tools for this job For Rover Coupé, Cabriolet & Tourer
- PARTEngine gasket setSearch: Rover Coupé, Cabriolet & Tourer engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.