–
| Loosen oil level control bolt -arrow-. |
Oil level is correct when the oil reaches the bottom edge of filling hole. |
–
| Tighten the gearbox oil level control plug -arrow- to a torque of 25 Nm. |
To fill the reservoir completely with new oil |
–
| Unscrew the oil level cap and top up to the lower edge of the filling orifice. |
–
| Screw in the cap and start the engine, let the gearbox run approx. 2 minutes with a gear selected. |
–
| Stop the engine, remove oil cap and check level again, top up if necessary. |
–
| Tighten the gearbox oil level control cap to a torque of 25 Nm. |
|
|
|