Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Gear selection mechanism

Make
SEAT
Model
Leon Mk1
Section
6-speed manual gearbox 01X › Gearbox mechanics,operation, construction,diff. › Gear selection mechanism
Power transmissionGear selection mechanism
Removing / fitting the gear lever knob and cover
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Pliers for spring-loaded band-type clamps -V.A.G 1275-, see equivalent → Anchor
  W00-0451
Removal:
Gear selection mechanism – SEAT Leon Mk1  Note
The gear knob is removed together with the gear lever boot and the cover for the centre console.
–  Open ashtray.
–  Unclip cover for centre console and lift it off -arrows-.
  A34-0417
Gear knob with clip:
–  Pull boot up and over gear knob.
–  Open clamp -arrow- and remove shift knob together with shift lever cover with clamp pliers - VAG 1275-.
  A34-0647
Gear knob with locking mechanism:
–  Release connecting piece -1- in direction of arrow and pull gear knob off upwards together with gear lever boot.
Installation
Installation is carried out in reverse order.
  A34-0418

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.