Leon Mk1
|
|
Note| t | You ca view the special tools required in the section »Axle of the reverse gear with selector gear of the reverse gear: Disassembling and assembling« → Chapter. |
| t | After removal, always renew needle bearings in clutch housing and in reverse shaft support. |
| 1 - | clutch housing |
| 2 - | Axial/radial needle bearing |
| q | Removing → Fig. |
| q | After installation, the axial/radial needle bearing must always be replaced. |
| q | Installing → Fig. |
| 3 - | Reverse shaft |
| q | With reverse gear wheel |
| q | Removing and installing → Chapter |
| 4 - | Reverse gear mobile element |
| q | Installation position: the splines must point to the speed selector gear for the reverse gear |
| 5 - | Plate |
| 6 - | Needle bearing |
| q | Reverse gear shaft of the mobile pinion |
| q | Lubricate with gear oil before installing |
| 7 - | Synchromeshed gear for reverse gear |
| q | Installation position: the splines must point to the locking collar for the reverse gear. |
| 8 - | Thrust washer |
| 9 - | Axial/radial needle bearing |
| q | Removing → Fig. |
| q | After removal, the axial/radial needle bearing must always be replaced. |
| q | Installing → Fig. |
| 10 - | Reverse shaft support |
| q | Removing and installing → Chapter |