Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Repair the clutch mechanism

Make
SEAT
Model
Leon Mk1
Section
6-speed manual gearbox 0BB › Clutch, control › Repair the clutch mechanism
Power transmissionRepair the clutch mechanism
   
Assembly overview - hydraulics (LHD)
Repair the clutch mechanism – SEAT Leon Mk1
1 - Brake fluid deposit
2 - Seal
q   The seals must be located in supply hose
3 - Circulation hose
4 - Master cylinder
q   Removing and installing → Chapter>>>>>>>>
5 - Clip
q   To remove and install pipe, pull out clip as far as it will go
6 - Seal / O-ring
q   Pull onto line connection
q   Lubricate with brake fluid before installing
q   Seals/O-rings are adapted to configuration of line connection → Fig.
q   Assignment → Electronic parts catalogue „ETKA“
7 - Mounting
q   To remove and install, separate master cylinder from clutch pedal → Chapter.
8 - Clutch pedal
q   Removing and installing → Chapter>>>>>>>>
9 - Hexagon nut, self-locking, → Item
10 - Pipe line
q   Assignment → Electronic parts catalogue „ETKA“
q   To remove, remove battery and battery tray → Electrical system; Rep. gr.27.
11 - Spring retainer
q   Fixed onto the bodywork
12 - Seal / O-ring
q   Pull onto line connection
q   Lubricate with brake fluid before installing
q   Seals/O-rings are adapted to configuration of line connection → Fig.
q   Assignment → Electronic parts catalogue „ETKA“
13 - Bleeder connection
14 - Seal / O-ring
q   Pull onto line connection
q   Lubricate with brake fluid before installing
q   Seals/O-rings are adapted to configuration of line connection → Fig.
q   Assignment → Electronic parts catalogue „ETKA“
15 - Clip
q   Pull out clip to stop to remove and install pipe line or bleeder.
16 - Vent valve
q   Bleed the clutch system → Chapter.
17 - Grease cap
18 - Slave cylinder
q   Can only be renewed after removing gearbox
q   Removing and installing, ⇒ Repairing clutch release mechanism, → Chapter
19 - Gearbox:

   
Seals and O-rings for pipe/hose line or pipe line
  N30-10294
ItemMaterial of line connection
1Line connection with circumferential groove -arrow 1-
2Line connection with shoulder -arrow 2-
3Line connection with shoulder -arrow 2- and circumferential groove -arrow 3-

l  For line connection having circumferential groove -arrow 1- and -arrow 3-, the seal or O-ring must be set there.
   

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.