Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Gearbox housing and clutch housing

Make
SEAT
Model
Leon Mk1
Section
6-speed manual gearbox 0BB › Gearbox mechanics,operation, construction,diff. › Gearbox housing and clutch housing
Power transmissionGearbox housing and clutch housing
   
Clutch housing: repairing
Gearbox housing and clutch housing – SEAT Leon Mk1
Special tools and workshop equipment required
t  Die -VW 407-
t  Mandrel -T10168-
t  pressure tool -T40008-
t  Inside extractor -1 - Kukko 21/2-
t  Inside extractor -1 - Kukko 21/4-
t  Counter-support -4 - Kukko 22/2-
t  Drift sleeve -30-21-
t  Pressing-off lever -VW 681-

   
Pulling out selector rod bearing bush
A - Counter-support, e.g. -Kukko 22/1-
B - Internal puller 14.5...18.5 mm, e.g. -Kukko 21/2-
  N34-1018
Driving in bearing bush for selector rod (drive in until tool contacts stop)
  N34-10307
Pulling needle bearing out of clutch housing
A - Counter-support, e.g. -Kukko 22/2-
B - Internal puller, 23.5…30 mm, e.g. -Kukko 21/4-
Gearbox housing and clutch housing – SEAT Leon Mk1  Note
The needle bearing is destroyed during removal and must be renewed.
  N34-1020
Pressing needle bearing -A- into clutch housing
–  Before pressing in, place reverse shaft thrust washer -B- onto needle bearing.
  N34-1021
Pressing reverse gear selector fork shaft into clutch housing
  N34-1120

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.