seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Roof lining > < Cross member

Leon Mk1

Releasing and securing moulded headliner without sliding/tilting sunroof
Releasing and securing moulded headliner without sliding/tilting sunroof
Releasing
–  Switch off ignition.
–  Remove interior rear view mirror → Chapter.
–  Remove emergency braking function sensor unit -J939- → Chapter.
–  Remove lights and switches from headliner → Electrical system; Rep. gr.96.
–  Remove upper left and right A-pillar trim → Chapter.
–  Remove upper left and right B-pillar trim → Chapter.
–  Remove left and right C-pillar trim → Chapter.
–  Remove left and right sun visors → Chapter.
–  Remove left and right sun visor mounts → Chapter.
–  Remove hand holds on left and right sides of roof → Chapter
   
–  Carefully unlatch retaining clips -1- from rear roof cross member.
  Note
Retaining clips -1- must always be renewed before installation.
–  Detach moulded headliner -2- from door seal beading and lower.
–  Lower moulded headliner -2- with help of second mechanic (danger of breakage).

Securing
  Note
Before installing, check all fasteners for damage and renew if necessary.
–  Installation is carried out in reverse order. The following should be taken into account:
–  Locate moulded headliner -2- with help of second mechanic.
–  Engage retaining clips -1- in roof cross member.
The remaining installation process is analogous.
   

Roof lining > < Cross member