t
| For fitting the selector lever -2-, the interlock button must be pulled out to the end and secured using a pin -1-(Ø approx. 2 mm). |
t
| If, by accident, the button was not secured, it must not be removed from the selector lever handle using auxiliary mechanical tools. Place a compressed air gun underneath the handle and make the button come out using compressed air. |
–
| Insert the complete selector lever handle -2- on to the selector lever; the button -1- must face in the direction of the driver. The handle should be set onto the selector lever housing. |
–
| Remove the pin or the fitting aid; the actuation of the button is then applied in the vertical groove on the selector lever. If necessary, use pressure to insert the button into the selector lever handle. |
|
|
|