SEAT Workshop Service and Repair Manuals

Radiator fan -V7- and fan 2 of the radiator -V177-: Removing and installing t  Removing → Anchor t  Fitting → Anchor t  Tightening torques → Anchor

Removing –  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.

–  Remove the air intake hose -arrow- between the lock carrier plate and the air filter housing.

–  Unscrew air duct at lock carrier -arrows-.

–  Remove the centre noise insulation, fastening points -1 … 3- → Bodywork, exterior fitting work; Rep. Gr.50.

–  Remove air hose (right-side) by lifting retaining clips -arrows- slightly. –  Unplug connector -1-.

–  Extract the bolts of the fan cowl -arrows-. –  Remove the fan cowl downwards.

–  Unplug connector -1-. –  Lay bare cables. –  Unscrew nuts -arrows- and take radiators out. Installing Fit in reverse order from removal, remembering the following: Fit the supercharger air system hoses and observe the assembly instructions → Chapter Tightening torques

Component	Nm
Radiator fan to fan cowl	10
Fan cowl to radiator	5