seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Flywheel: Removing and installing > < Sealing flange, flywheel side: Replace.

Leon Mk1

Engine speed senderG28: Removing and installing
Engine speed sender -G28-: Removing and installing
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  AF-4mm wrench -T10370-, see equivalent → Anchor
  W00-10582
t  Hose clamp -3094-, see equivalent → Anchor
t  Extractor -T10118-, see equivalent → Anchor
  W00-0079
Removal:
–  Remove the central sound insulation → Exterior body installation work; Rep. Gr.50.
–  Choke the coolant hoses using the pressure clamp on the oil radiator side and release them.
–  Remove the oil filter bracket → Chapter.
–  Unplug the electrical connector on the engine speed sender -G28- using the assembly device -T10118-.
  Note
To release the electrical connection without using the assembly device -T10118-, press the connector on the engine speed sender using a screwdriver and, at the same time, lift the release button using a thin wire hook.
  A10-1565
–  Remove the bolt -Arrow- with the 4 mm socket -T10370- and take out the engine speed sender -G28-.
Installation is carried out in the reverse order, noting the following: The tightening torque for the fixing bolts of the engine speed sender -G28- is 5 Nm.
  N13-10048

Flywheel: Removing and installing > < Sealing flange, flywheel side: Replace.