seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Drive plate: Removing and installing > < Crankshaft oil seal, pulley side: replacing

Leon Mk1

Flywheel: removing and installing
Flywheel: removing and installing
Special tools and workshop equipment required
   
t  Torque wrench -SAT 8010-
  L00-10226
t  Counterhold -T20176-
Removing
l  Gearbox removed.
–  Mark the flywheel with respect to the engine.
  W00-2458
–  Fit counter-hold -T20176- in the cylinder hole block and align flywheel.
–  Unbolt flywheel.
Fitting
Installation is carried out in the reverse order to removal, observing the following:
–  Invert the position of the counterhold -T20176- to immobilise the flywheel when tightening the bolts
–  Use new bolts and tighten to prescribed torque → Item.
  E13-10015

Drive plate: Removing and installing > < Crankshaft oil seal, pulley side: replacing