Leon Mk1
Part I Timing belt system - Assembly overview |
1 - | Bolt |
q | Tightening torque: 20 Nm |
2 - | Poly V-belt for the coolant pump pulley |
q | Removing and installing, coolant pump → Chapter |
q | Use counterholdl -T20159- to loosen and tighten. |
3 - | Bolt |
q | Tightening torque: 40 Nm |
4 - | Washer |
5 - | Idler roller for poly V-belt |
q | removing and fitting → Chapter |
6 - | Washer |
7 - | Spacer bush |
8 - | Bolt |
q | Tightening torque: 25 Nm |
9 - | Alternator |
q | Removing and fitting → Electrical system; Rep. gr.27 |
10 - | Spacer bush |
11 - | Securing bolt |
q | replace |
q | The contact surfaces of the fastening screws may not contain any oil or grease residue. |
q | Apply oil prior to installation (thread) |
q | Secure the poly-V belt with the retaining tool -3415- against twisting |
q | Tightening torque: 150 Nm + 180° |
12 - | Poly V-belt pulley for crankshaft |
q | Removing and installing crankshaft pulley → Chapter |
q | The contact surfaces may not contain any oil or grease residue. |
13 - | Bolt |
q | Torque setting 20 Nm + 90° |
14 - | Poly V-belt tensioning element |
q | Lock with locking tool -T10060A-. |
15 - | Bolt |
q | Tightening torque: 25 Nm |
16 - | Air conditioning compressor |
q | Removing and installing → Heating, ventilation, air conditioning system; Rep. gr.87 |
17 - | Centring sleeve |
18 - | Poly-V belt |
q | mark the direction of rotation prior to removal |
q | removing and fitting → Chapter |