To fit the sealing flange with the sender wheel to the crankshaft |
Note t
| The sealing flange with the PTFE seal is fitted with a pressure ring on the sealing lip. This pressure ring fulfils the function of an assembly sleeve and cannot be removed before fitting. |
t
| Once unwrapped, do not remove the sealing flange from the sender wheel or twist them. |
t
| The sender wheel is held in its installation position on the assembly device -T10134- by a locating pin. |
t
| Sealing flange and oil seal form one unit and must only be renewed together with the sender wheel. |
t
| The assembly tool -T10134- is held in its installation position for the crankshaft by a guide pin which is inserted into a hole on the crankshaft. |
|
|
|