seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing turbocharger > < Turbocharger|Part I:

Leon Mk1

Part II:
   
Part II:
1 - 8 Nm
2 - Coolant pipe
3 - O ring
q   Replace
4 - Turbocharger
q   Stud tightening torque: 20 Nm
q   Removing and installing → Chapter.
q   Checking turbocharger vacuum unit → Chapter.
q   Removing and installing vacuum unit for turbocharger → Chapter.
q   Adjusting vacuum unit for turbocharger → Chapter.
5 - Seal
q   Replace
6 - Support
  Note
t  Retainer is discontinued.
t  The retainer is not reinstalled in cases of repair.
7 - Support
  Note
t  Retainer is discontinued.
t  The retainer is not reinstalled in cases of repair.
8 - 25 Nm
Observe correct tightening sequence: Positions -A- to -I-
9 - Coolant pipe
10 - Seal
q   Replace
11 - 8 Nm
12 - Oil return pipe
13 - Seal
q   Replace
14 - Banjo bolt, 20 Nm
q   Secured to valve timing housing.
15 - Oil supply pipe
  Caution
Oil supply line must be renewed when installing a new turbocharger.
16 - Banjo bolt, 30 Nm

   

Removing and installing turbocharger > < Turbocharger|Part I: