Running gearRepairing rear brakes
| Assembly overview - rear brake CII 41 |

Note | t
| Use the brake filling and bleeding equipment -VAS 5234- or the extraction unit -V.A.G 1869/4- to draw off brake fluid from the brake fluid reservoir. |
| t
| Before removing a brake caliper or disconnecting a brake hose, fit brake pedal depressor -V.A.G 1869/2- (when doing this, release pressure in system). |
|
|
|

|
q
| Allocation ⇒Electronic Parts Catalogue (ETKA) |
|
q
| When worn, renew on both sides of axle. |
|
q
| Remove brake caliper and brake carrier prior to removing. |
| 4 - | Multi-point socket head bolt - 90 Nm and turn 90° further |
|
q
| Always renew if removed |
|
q
| Remove and install with socket wrench XZN 14 -T10035- → Fig. |
| 5 - | Brake back plate with guide pins and protective cover |
|
q
| Supplied as genuine part, assembled with sufficient grease on guide pins. |
|
q
| If the protective covers or the guide pins have been damaged, fit the whole repair unit. Use lubricant sachet supplied to lubricate guide pins. |
|
q
| Always replace when brake pads are replaced |
|
q
| Thickness: 11 mm not including backplate. |
|
q
| Wear limit: 2 mm without dorsal plate |
|
q
| Always renew on both sides of axle |
|
q
| Thickness: 11 mm not including backplate. |
|
q
| Wear limit: 2 mm without dorsal plate |
|
q
| Always renew on both sides of axle |
|
q
| Always replace when brake pads are replaced |
| 10 - | Hexagon bolt, self-locking, 35 Nm |
|
q
| Do not unscrew hose when replacing brake pads |
|
q
| Basic setting must be carried out after repair work or renewal. |
| 13 - | Parking brake motor. |
| 14 - | Torx socket head bolt, 12 Nm |
| 16 - | Brake hose with ring hose connection and hollow bolt 35 Nm |
02 Steering & suspension
The same page in:
Leon Mk2.