Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk102 · Running gear
02 · Steering & suspension

Brake calliper FN3

Make
SEAT
Model
Leon Mk1
Section
Brake system: › Brakes, hydraulics, regulator, servo › Brake calliper FN3
Running gearBrake calliper FN3
Removing and installing pistons for front brake calliper
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Removal wedge -3409-, see equivalent → Anchor
  W00-0016
t  Piston resetting tool -T10145 -, see equivalent → Anchor
t  Assembly paste → Spare parts catalogue
Removal:
  W00-1309
–  Force piston out of brake calliper housing using compressed air.
Brake calliper FN3 – SEAT Leon Mk1  Note
Place a piece of wood in the cavity so that the piston does not get damaged.
  V47-0308
–  Remove the seal ring.
–  To do this use removal wedge -3409-.
Brake calliper FN3 – SEAT Leon Mk1  Note
When removing protect the cylinder from damage.
Installation
  V46-0970
–  Insert sealing ring.
–  To do this use removal wedge -3409-.
  V46-0970
–  Fit the protective hood with the outer sealing lip over the piston.
–  The piston and join ring surfaces can only be cleaned using alcohol and immediately dried.
–  Before fitting the piston and seal ring, apply a thin coating of assembly paste → Parts catalogue
  A47-0040
–  Using the removal wedge -3409-, insert the inner sealing lip into the groove of cylinder.
Brake calliper FN3 – SEAT Leon Mk1  Note
When doing this hold piston in front of calliper housing.
  N47-0081
–  Insert the brake calliper piston using the tool - T10145 -.
Brake calliper FN3 – SEAT Leon Mk1  Note
The outer sealing lip of the protective cap will then locate in the groove on the piston.
  A47-10027

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.