Running gearVacuum system

Note | t
| The average earth atmospheric pressure at sea level is 1.013 mbar and falls the higher you travel (approx. 100 mbar / 1,000 m height). Local and time fluctuations also influence vacuum generation. |
| t
| A cold engine, a switched-on air-conditioning system as well as engine idling have an adverse influence on generation of a vacuum. |
| –
| Before starting work, check all vacuum hoses for damage (e.g. cracks or marten bite) and to check that they are correctly and firmly attached |
| –
| Connect brake servo vacuum gauge -VAS 6721- → Chapter. |
| –
| Open cut-off valve -A-. |
|
|
|
| –
| Close cut-off valves -B+C-. |
| –
| Start warm engine (>60° C), press accelerator briefly (engine speed greater than 2000/min). |
| Normally (see notes), the vacuum that is generated should be between 600 and 950 mbar (depending on engine size). |
|
|
|
| –
| Open cut-off valve -C- to evacuate brake servo. |
| –
| Read and make a note of measured value shown. |
| A vacuum decrease of 400 mbar in 12 hours is permissible. |
| If the vacuum decrease is greater, check for leaks in the vicinity of ... |
| 2 - | non-return valve, vacuum hoses with connectors or vacuum pump/intake manifold |
| If there are large leaks, the vacuum decreases steeply within a few seconds. |
| Vacuum check in vicinity of brake servo: |
|
|
|
| –
| After generation of vacuum, close cut-off valve -A- in order to check brake servo vacuum system. |
| Vacuum check in vicinity of non-return valve, vacuum hoses with connectors and vacuum pump/intake manifold: |
|
|
|
| –
| Once vacuum pressure has been generated, close shut-off valve -C- in order to check vacuum system using brake servo vacuum gauge -VAS 6721- up to intake manifold or vacuum pump. |
| Open cut-off valve -B- to facilitate removal of hose connections and adapter. |
|
|
|
02 Steering & suspension
The same page in:
Leon Mk2.