Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk102 · Running gear
02 · Steering & suspension

Front brake calipers

Make
SEAT
Model
Leon Mk1
Section
Brake system: › Brakes, hydraulics, regulator, servo › Front brake calipers
Running gearFront brake calipers
Removing and installing brake caliper piston
Special tools and workshop equipment required
   
t  Removal wedge -3409-
  W00-0016
t  Piston resetting appliance -T10145-
Removing:
–  Force piston out of brake caliper using compressed air.
  W00-1309
Place a piece of wood in the cavity so that the piston does not get damaged.
  S47-0051
–  Remove seal using wedge 3409.
When removing protect the cylinder from damage.
Installing:
–  The surfaces of the piston and seal must be cleaned only with methylated spirits and then dried.
–  Thinly coat piston and seal with assembly paste G 052 150 A2 before inserting.
–  Insert the seal into the brake caliper.
  N47-0040
–  Place protective cap with outer sealing lip on piston.
  N47-0079
–  Insert inner sealing lip into groove in cylinder using wedge 3409.
When doing this, hold piston in front of brake caliper.
  N47-0059
–  Press piston into brake caliper using piston resetting tool.
The outer sealing lip on the protective cap will then slip into the piston groove.
  V47-0409

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.