–
| Unscrew the bolts (from above) -arrows-. |
–
| Remove the gear selection mechanism and the selector lever cable by pulling downwards. |
–
| Do not bend or kink the selector lever cable. |
The gear selection mechanism may also be replaced without the selector cable; To do so, it is necessary to separate the selector lever cable from the gear selection mechanism and detach the cable → Chapter. |
Gear change mechanism: fitting |
Install in reverse order. The following must be taken into account: |
For information about tightening torques of nuts and bolts and whether it is necessary to replace them, see the chapter, Gear selection mechanism: removing and fitting - Component overview → Chapter. |
–
| Do not bend or kink the selector lever cable. |
–
| Fit the heat shield and the trimmings from the vehicle underbody. |
–
| Fit the gear selection mechanism cover and the selector lever handle → Chapter. |
–
| Check functioning of the ignition key withdrawal lock control unit → Chapter. |
–
| Adjusting the selector lever cable → Chapter |
|
|
|