Leon Mk1
| Assembly overview |
| 1 - | Sump |
| q | Removing and fitting → Chapter |
| 2 - | Bolt M6 |
| q | Always replace |
| q | 5 units, for fixing the oil sump with the oil sump gasket to the gearbox casing |
| q | Tightening torques: 10 Nm |
| 3 - | Seal |
| 4 - | Bolt M6 |
| q | Always replace |
| q | To fit the DSG automatic gear mecatronic system -J743- to the gear casing |
| q | Tightening torques: 5 Nm + 90° (1/4 turn) |
| 5 - | DSG automatic gear mecatronic system -J743- |
| q | with O-ring on the connector |
| q | Replace all O-rings |
| q | Removing and fitting → Chapter |
| 6 - | Bleeder hose |
| q | Fits in the gearbox |
| q | It should be replaced if it is removed |
| 7 - | Breather cap |
| q | This is encased in the air extraction pipe |
| 8 - | ATF radiator |
| q | Removing and fitting → Chapter |
| 9 - | Bolt M8 |
| q | Always replace |
| q | To fix the transmission oil radiator to the gearbox housing |
| q | Tightening torques: 20 Nm + 90° (1/4 turn) |
| 10 - | O-ring |
| q | Always replace |
| 11 - | Counter support |
| 12 - | Bolt M8 |
| q | Always replace |
| q | 2 units, for fixing the counterhold to the gearbox housing |
| q | Tightening torques: 20 Nm + 90° (1/4 turn) |
| 13 - | Filter housing |
| q | Tightening torque on the gearbox: 20 Nm |
| 14 - | Gear oil filter |
| q | Removing and fitting → Chapter |
| 15 - | Gear oil pump |
| q | Removing and fitting → Chapter |
| 16 - | Bolt M6 |
| q | Always replace |
| q | 4 units for fixing the oil pump to the gearbox housing |
| q | Tightening torques: 5 Nm + 90° (1/4 turn) |
| 17 - | Gear oil pump cover |
| q | With seal |
| q | Removing and fitting → Chapter |
| 18 - | Bolt M6 |
| q | 4 units, for fixing the cover to the gearbox housing |
| q | Always replace |
| q | Tightening torques: 8 Nm |
| 19 - | Drain plug M24 |
| q | Tightening torques: 45 Nm |
| 20 - | Seal |
| q | Always replace |
| 21 - | Check plug M24 |
| q | Tightening torques: 45 Nm |
| 22 - | Seal |
| q | Always replace |
| 23 - | Overflow pipe |
| q | Tightening torques: 3 Nm |
| 24 - | Protection plate |
| 25 - | Bolt M10 |
| q | 4 units, for fixing the protective plate to the gearbox housing |
| q | Tightening torques: 32 Nm |
|
|