seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gear oil pump: removing and installing > < DSG automatic gear mecatronic system J743 : removing and fitting

Leon Mk1

Hybrid sensorG182, G93: removing and installing
Hybrid sensor -G182, G93-: removing and installing
Consult the tool and equipment equivalence tables for Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque spanner kit -SAT 8010-, see equivalent → Anchor
  L00-10226
t  Tray -T20173-, see equivalent → Anchor
t  Protection glasses
l  Engine off.
  WARNING
If the oil sump has been removed or if gear oil is needed, do not start the engine or tow the vehicle.
  Note
t  Cleaning norms when working on automatic gearbox → Chapter.
t  General repair instructions → Chapter.
t  Moisten the O-rings and seals with gear oil. Other lubricants may cause malfunctions in the hydraulic control of the gearbox
Hybrid sensor -G182, G93-: removing
  WARNING
Take all the necessary precautionary measures when connecting the battery → Electrical system; Rep. Gr.27
  W00-2455
–  With ignition switched off, connect earth connection-arrow-to battery → electrical system; Rep. Gr.27.
–  Remove oil sump → Chapter.
–  Remove the DSG automatic gear mecatronic system -J743- → Chapter
  A27-0191
–  Screw out bolt -B-.
–  Remove the hybrid sensor -A- from the gearbox with the cable.
Hybrid sensor -G182, G93-: fitting
Installation is carried out in reverse order, noting the following:
–  Moisten the hybrid sensor -A- with gear oil and insert it in the lateral opening of the gearbox.
–  Tighten the new bolt (M6) -B- to 10 Nm.
  A37-0676
–  Fitting the Mecatronic unit -C - → Chapter.
  Note
When installing the mecatronic unit for the DSG automatic gearbox -J743- take care not to trap the connector cable -A-. If the cable is damaged, the hybrid sensor -G93, G182- must be replaced. → Chapter
–  Attach cable to clips -arrows-.
–  Attach connector -A-.
–  Fit the oil sump → Chapter.
–  Connect battery → Electrical system; Rep. Gr.27.
–  Take all the necessary precautionary measures after connecting the battery → Electrical system; Rep. Gr.27
–  Fill with gear oil → Chapter
–  Make the basic adjustment using the central diagnosis -VAS 5051B- or central diagnosis -VAS 5052-.
  A37-0673

Gear oil pump: removing and installing > < DSG automatic gear mecatronic system J743 : removing and fitting