Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk201 · Power transmission
01 · Transmission

Clutch: repair

Make
SEAT
Model
Leon Mk2
Section
085 5-speed manual gearshift › Clutch, control › Clutch: repair
Power transmissionClutch: repair
   
Clutch: repair
Assembly chart
Clutch: repair – SEAT Leon Mk2  Note!
t  Always replace clutch plates and clutch presses that have loose or damaged rivets.
t  When replacing, assign the clutch plate and press according to the Replacement Parts Microfiche.
t  For working on the clutch, it is necessary to dismount the vehicle's gear box differential.
Diagram not available
1 - Engine flywheel
q   When fitting the clutch plate, check that the centering pins are firmly set.
q   The contact surface with the clutch plate should be clean of oil and grease and without gashes or grooves.
q   Dismounting and assembly of the engine flywheel → Rep. Gr.13 of the corresponding engine
2 - Clutch plate
q   When replacing, assign according to the Replacement Parts Microfiche.
q   Lightly grease the strias.
q   Assembly position: the spring cage should face the clutch plate.
q   Clutch plate centering → Fig.
Clutch: repair – SEAT Leon Mk2  Note!
Clean the strias of the primary shaft and the clutch plate. Remove the rust from used clutch plates. Apply a fine layer of -G 000 100- grease on the strias of the primary shaft. With a to-and-fro movement, move the clutch plate on the primary shaft until it gently slides. Remove any excess grease.
3 - Clutch plate
q   Dismounting and assembly → Fig.
q   Check the edges of the diaphragm → Fig.
Clutch: repair – SEAT Leon Mk2  Note!
Clutch plates are greased and protected against rust. Clean only the clutch plate contact surface of any grease or oil, otherwise the working life of the clutch will be reduced.
4 - Screw, 20 Nm

Special tools and workshop equipment required
   
t  Shank and locators for fitting the clutch plate -U-10050A-
  Diagram not available
t  Tool for clamping the engine flywheel -T20075-
Dismounting and assembling the clutch plate
–  To remove and fit the clutch press: block the turn of the engine flywheel with tool -T20075-.
–  Use tool -U-10050A/E- for centering the clutch plate.
Clutch: repair – SEAT Leon Mk2  Note!
t  The contact surfaces of the clutch press and clutch pedal should totally rest against the engine flywheel.
t  Always loosen and tighten screws in diagonal order and in various stages to avoid damaging the holes in the clutch or the centering bolts on the flywheel.
  Diagram not available
Check the edges of the diaphragm on the clutch press
–  Wear of up to half the thickness of the diaphragm is acceptable.
  Diagram not available

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.