Power transmissionRepairing clutch
Diagram not available| Special tools and workshop equipment required |
| t
| Centring mandrel -T10097- |
| t
| Torque wrench -V.A.G 1331- |
| Removing and installing gearbox (gearbox without threaded hole in housing) → Chapter |
| –
| Following clutch repair, observe the following before installing gearbox: |
| –
| Renew O-ring on stub shaft. |
| t
| Grease right flange shaft splines and area around O-ring on stub shaft with constant velocity joint grease -G 052 738 A2-. |
| t
| Check whether dowel sleeves for aligning engine and gearbox are fitted in cylinder block and install if necessary. |
| t
| If dowel sleeves are not fitted, difficulties shifting gear, clutch problems and possible noises from the gearbox (rattling of gears which are not engaged) could occur. |
|
|
|

Note!
| t
| Replace clutch plates and pressure plates having damaged or loose rivets. |
Diagram not available|
q
| Ensure that centring pins fit tightly |
|
q
| Contact surface for clutch lining must be free of grooves, oil and grease |
|
q
| Installation position on dual-mass flywheel → Fig. |
|
q
| Installation position with single piece flywheel: spring cage faces pressure plate |

Note!
| Clean input shaft splines and, on used clutch plates, hub splines; remove corrosion and apply only a very thin coat of grease -G 000 100- to the input shaft splines. Then move clutch plate to and fro on input shaft until hub moves freely on shaft. Remove excessive grease. |
|
q
| Removing and installing → Fig. |
|
q
| Resetting adjuster ring of pressure plate in vehicles with 6-cylinder engines → Chapter |
|
q
| Check ends of diaphragm spring → Fig. |

Note!
| Pressure plates are protected against corrosion and greased. Clean contact surface only; otherwise the service life of the clutch will be considerably reduced. |
|
q
| On single-piece flywheel |
|
q
| Loosen or tighten diagonally and in steps |
| Clutch plate installation position on dual-mass flywheel |
| l
| The text “Getriebeseite” (gearbox side) or “Getr.-Seite”-arrow- always faces pressure plate and gearbox. |
|
|
Diagram not available
|
| –
| Loosen or tighten bolts diagonally in stages. |
| –
| Reverse position of counterhold -3067- when removing. |

Note! | t
| Pressure plate contact surface and clutch plate lining must make full contact with flywheel. |
| t
| Tighten securing bolts diagonally and evenly to prevent damage to the pressure plate centring hole and the flywheel centring pins. |
| t
| The adjusting ring on the self-adjusting pressure plate must be reset only when a new clutch plate is fitted → Chapter. |
|
|
Diagram not available
|
| Checking ends of diaphragm spring |
| l
| Wear up to half the thickness of the diaphragm spring is permitted. |
|
|
Diagram not available
|
01 Transmission
The same page in:
Leon Mk1.