| Using the pipe seam tool -VAS 6056- the brake pipes with an exterior diameter of 5 mm may be re-edged without damaging the covering. Thus, in certain cases, sections of pipe may be replaced more economically. |
| The edge cutting equipment -VAG 1356- cannot be used due to the coating and diameter of the black brake pipes. |
Note | t
| The brake pipes can only be bent up to a maximum of 90°; otherwise they may break due to the bending, or the cross-section may be deformed from being over stretched. |
| t
| It is preferable to disconnect the brake pipes on the side of the vehicle floor. |
| t
| Choose the position of the intermediate elements so that they do not rub on mobile elements. |
| t
| Do not lubricate the edge cutting spindle, use alcohol to clean it. |
| Special tools and workshop equipment required |
|
|
|
