Vehicle electricsReconnecting battery
Caution | Observe notes for battery terminal clamp bolt → Chapter. |
|
| Special tools and workshop equipment required |
|
|
|
| t
| Torque wrench -V.A.G 1331- |
Note | After the battery has been reconnected and the ignition is switched on, the ESP and TCS stabilisation programme warning lamp -K155- and the warning lamp for electromechanically assisted steering will light up permanently. The signal lamps switch off automatically when you drive on a straight route at a speed of 15 to 20 km/h. In this way, the steering angle sensor -G85- is reactivated. |
|
|
Diagram not available
|
| –
| Push positive cable terminal clamp -2- onto the positive terminal of battery and then tighten securing nut to prescribed torque → Chapter. |
| –
| Push earth cable terminal clamp -1- onto the negative terminal of battery and then tighten securing nut to prescribed torque → Chapter. |
| –
| Work through steps listed in table after connecting. |
| Steps after connecting battery |
|
|
Diagram not available
|
| Operation | Performed |
| Switch ignition on with ignition key or start button and then switch off again. | |
| Interrogate the event memory: → Guided fault finding using the vehicle diagnosis tester. | |
| Clock: check the time; set it if necessary | |
Electric window regulators:| –
| Open and close all windows to limit stop in each case. |
| –
| Finally when window is closed, pull the switch until the relay audibly switches. |
| –
| Check convenience functions of window regulator. The window must close fully in the convenience mode, without holding the switch. |
| |
Radio or radio and navigation system:
Check function, recode radio if necessary | |
Clock:
Check time setting and reset if necessary | |
| Function check: all electrical consumers | |
| Table can be printed out if necessary. |
| –
| Fit battery box cover or cover tab of battery protective jacket. |
|
|
|
06 General
