Workshop Manuals Factory service & repair Skoda
01 Running gear02 Engine03 Body04 Drive unit05 Power transmission06 Vehicle electrics07 Heating, ventilation, air conditioning system08 Power unit
Skoda Fabia Mk201 · Running gear
01 · Steering & suspension

Assembly overview of the handbrake

Make
Skoda
Model
Fabia Mk2
Section
Brake, brake mechanics › Handbrake › Assembly overview of the handbrake
Running gearAssembly overview of the handbrake
   
Assembly overview of the handbrake
Assembly overview of the handbrake – Skoda Fabia Mk2
1 - Handbrake lever
q   Removing the centre console → Body Work; Rep. gr.68
q   Assignment → Electronic Catalogue of Original Parts
2 - Cover
q   removing:
–  Press down the catch pegs at the bottom of the trim panel with a small screwdriver and pull off the trim towards the front.
q   Installing:
–  Slide the trim panel until the catch peg catches onto the hand-brake lever. Check trim panel catch.
q   Assignment → Electronic Catalogue of Original Parts
3 - Compensating clamp
4 - Adjusting nut
q   Setting the hand-brake → Chapter
5 - Grommet
q   removing:
–  Pull hand-brake cable from guide tube.
–  Release grommet.
–  Pull grommet from guide tube.
q   Installing:
   Installation is carried out in the reverse order. After installing make sure the grommet fits correctly in the body recess.
6 - Right guide tube
q   for hand-brake cable
7 - Left guide tube
q   for hand-brake cable
8 - Hand-brake cable
q   removing and installing → Chapter
9 - Hand-brake lever support
q   welded to the body tunnel
10 - Switch for hand-brake control -F9-
q   clipped onto hand-brake lever
q   replace if defective
11 - Self-locking nut, 20 Nm + 90°
q   replace after each removal

   

Parts & tools for this job For Skoda Fabia

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.